Cílem bakalářské práce je povrchová úprava materiálu MS1 vytvořená 3D tiskem pomocí vláknového nanosekundového laseru. Jednotlivé kapitoly pojednávají o jednotlivých parametrech laseru, nastavení laseru při laserovém mikroobrábění a vliv jednotlivých parametrů na výslednou kvalitu povrchu spolu s experimentem. Cílem byla optimalizace jednotlivých parametrů za účelem dosažení co nejlepší kvality povrchu materiálu.
Anotace v angličtině
The main aim of bachelor thesis is the surface treatment of 3D printed metal parts by low-cost nanosecond fiber laser. The chapters of this thesis discuss about parameters of laser, setting of the laser for laser micromachining and influence of each parametrs on final surface quality and the experiment. The aim of this thesis is the optimalization of parameters to reach the best surface quality possible.
Cílem bakalářské práce je povrchová úprava materiálu MS1 vytvořená 3D tiskem pomocí vláknového nanosekundového laseru. Jednotlivé kapitoly pojednávají o jednotlivých parametrech laseru, nastavení laseru při laserovém mikroobrábění a vliv jednotlivých parametrů na výslednou kvalitu povrchu spolu s experimentem. Cílem byla optimalizace jednotlivých parametrů za účelem dosažení co nejlepší kvality povrchu materiálu.
Anotace v angličtině
The main aim of bachelor thesis is the surface treatment of 3D printed metal parts by low-cost nanosecond fiber laser. The chapters of this thesis discuss about parameters of laser, setting of the laser for laser micromachining and influence of each parametrs on final surface quality and the experiment. The aim of this thesis is the optimalization of parameters to reach the best surface quality possible.
GIBSON, I., ROSEN, D. W., STUCKER, B. Additive Manufacturing Technologies: Rapid Prototyping to Direct Digital Manufacturing. Springer, 2010, ISBN 978-1-4419-1119-3
SCHERER, M. R. J. Double-Gyroid-Structured Functional Material. University of Cambridge, UK, 2013, ISBN 978-3-3-319-00353-5
BÁRTOLO, P. J. et al. Virtual and Rapid Manufacturing: Advanced Research in Virtual and Rapid Prototyping, Taylor & Francis Group, London, UK, 2008, ISBN 978-0-0415-41602-3
Seznam doporučené literatury
GIBSON, I., ROSEN, D. W., STUCKER, B. Additive Manufacturing Technologies: Rapid Prototyping to Direct Digital Manufacturing. Springer, 2010, ISBN 978-1-4419-1119-3
SCHERER, M. R. J. Double-Gyroid-Structured Functional Material. University of Cambridge, UK, 2013, ISBN 978-3-3-319-00353-5
BÁRTOLO, P. J. et al. Virtual and Rapid Manufacturing: Advanced Research in Virtual and Rapid Prototyping, Taylor & Francis Group, London, UK, 2008, ISBN 978-0-0415-41602-3